M5 Hotend Set (with Cooling Block)

Original Ankermake M5 printer had a major failure and was returned under warranty about a week after purchasing this hot end as a backup. Ankermade would not accept cost to return this now unnecessary part. I guess what should I expect from a 3D printer company that now does not make 3D printers.

Moving the products to a different brand name doesn't insulate you from the disapproval of valued and loyal customers, it is offensive and insulting to our intelligence. Faulty manufacturing is fixable through iteration but you instead try to cover up the problem and hope it goes away? I thought Anker was much better than this.

Heat block works Great, But this is the third time I have had to replace. I just wish there were a little or any protection for the wires esp temp sensor, What happens is when a print goes bad it engulfs the printhead destroying the wires
YES I should be watching more closely but after a while the machine gives a false sense of security because it is very reliable then WHAM you get the mother of all print clogs and filament overpowers the printhead Must be some way to protect against this sensor switch better design of wire routing?

Your 3D printer is bad and I am never going to use it in the future. Wish I had never bought it.

They were very quick in sending the parts out. I bought them as back up, but ended up installing the hot end due to an issue that arose after I got it. Pretty coincidental. It fit perfectly and functioned exceptionally well.